FEFCO 0503 Box Template Generator

Sleeve around the ends. A glued tube that closes the two ends and the top and bottom, leaving the long faces open. The shortest of the three sleeve components.

Not yet plate-checked. This template folds, closes and exports cleanly, but its blank has not yet been matched against the standard's own drawing in detail. Treat it as a starting point and check it before you spend anything.

What is FEFCO 0503?

FEFCO 0503 is made from more than one piece, with an inner tray or frame sliding inside an outer sleeve. A glued tube that closes the two ends and the top and bottom, leaving the long faces open. The shortest of the three sleeve components.

Uses

High-volume packing lines, since a pre-glued blank erects in one movement

Advantages

Cut from a single blank, so there is one tool and one part to stock
Arrives glued and flat, and erects quickly by hand or by machine
The two parts can be made from different boards, or printed differently

Disadvantages

The glued joint sets the minimum order — short runs are rarely economical

Typical industries

General packing and light manufacturing

Recommended board grades

Single wall E or B flute, or solid board for the smaller sizes. Both pieces are usually the same board so the slide fit stays predictable.

At a glance

Code	`0503`
Family	Corrugated (FEFCO)
Blank size at this size	642 × 303 mm
Panels	5
Creases	4

No plate badge, and the reason is measured rather than doubted. This blank shares a fold topology with its siblings in its group, and scored against each of their plates through scripts/settle-shared.py it reaches 1.000 on a rival against 1.000 on its own. A fit that solves for proportions cannot tell two same-topology plates apart, so a match here rules other readings OUT rather than ruling this one in — see the docstring in scripts/grant-badges.py. Rival scores: 0502 1.000, 0501 0.750. The drawing itself is not in question; only the claim that it was checked against THIS plate rather than a sibling.

Get the dieline

The generator draws this style to whatever dimensions you enter and exports it as a 1:1 PDF, an SVG, or a DXF with the cut, crease and perforation lines on separate layers. Nothing to sign up for.

Open 0503 in the generator