FEFCO 0510 Box Template Generator

Slide box, end sleeve over side sleeve. The matchbox pairing reversed: the tube closing the top and bottom goes on the outside, wrapping the one that covers the sides. Puts the printed face where the seam does not show.

Not yet plate-checked. This template folds, closes and exports cleanly, but its blank has not yet been matched against the standard's own drawing in detail. Treat it as a starting point and check it before you spend anything.

What is FEFCO 0510?

FEFCO 0510 is made from more than one piece, with an inner tray or frame sliding inside an outer sleeve. The matchbox pairing reversed: the tube closing the top and bottom goes on the outside, wrapping the one that covers the sides. Puts the printed face where the seam does not show.

Uses

Retail and gift packaging, where the box is seen by the customer
Jobs where the depth or the fit has to be adjusted after packing

Advantages

The two parts can be made from different boards, or printed differently

Disadvantages

Needs 2 separate pieces, so there is more than one tool and more than one part to handle

Typical industries

General packing and light manufacturing

Recommended board grades

Single wall E or B flute, or solid board for the smaller sizes. Both pieces are usually the same board so the slide fit stays predictable.

At a glance

Code	`0510`
Family	Corrugated (FEFCO)
Blank size at this size	1070 × 426 mm
Panels	10
Creases	8

No plate badge, and the reason is measured rather than doubted. This blank shares a fold topology with its siblings in its group, and scored against each of their plates through scripts/settle-shared.py it reaches 0.997 on a rival against 1.000 on its own. A fit that solves for proportions cannot tell two same-topology plates apart, so a match here rules other readings OUT rather than ruling this one in — see the docstring in scripts/grant-badges.py. Rival scores: 0507 0.997, 0504 0.500, 0505 0.500, 0509 0.500. The drawing itself is not in question; only the claim that it was checked against THIS plate rather than a sibling.

Get the dieline

The generator draws this style to whatever dimensions you enter and exports it as a 1:1 PDF, an SVG, or a DXF with the cut, crease and perforation lines on separate layers. Nothing to sign up for.

Open 0510 in the generator