Double-wall webbed tray Box Template Generator

Double-wall webbed tray. Every wall doubled, every corner webbed, and the tuck tabs relieved so it folds up by hand and then goes through a gluer for the corners. A stiff, fully finished tray for retail sets.

Not yet plate-checked. This template folds, closes and exports cleanly, but its blank has not yet been matched against the standard's own drawing in detail. Treat it as a starting point and check it before you spend anything.

What is Double-wall webbed tray?

Double-wall webbed tray is a folding carton with a glued side seam, closing at each end with a tuck, a lock or a glued flap. Every wall doubled, every corner webbed, and the tuck tabs relieved so it folds up by hand and then goes through a gluer for the corners. A stiff, fully finished tray for retail sets.

Uses

Retail and gift packaging, where the box is seen by the customer
High-volume packing lines, since a pre-glued blank erects in one movement

Advantages

Cut from a single blank, so there is one tool and one part to stock
Arrives glued and flat, and erects quickly by hand or by machine

Disadvantages

The glued joint sets the minimum order — short runs are rarely economical

Typical industries

General packing and light manufacturing

Recommended board grades

Folding boxboard or solid bleached board, typically 250–450 microns. Heavier board for larger cartons, lighter where the carton is filled by machine.

At a glance

Code	`B48.21.00.00`
Family	Folding carton (ECMA)
Also known as	double wall webbed tray
Blank size at this size	620 × 471 mm
Panels	17
Creases	20

No plate badge, and the reason is measured rather than doubted. This blank shares a fold topology with its siblings in its group, and scored against each of their plates through scripts/settle-shared.py it reaches 0.963 on a rival against 0.963 on its own. A fit that solves for proportions cannot tell two same-topology plates apart, so a match here rules other readings OUT rather than ruling this one in — see the docstring in scripts/grant-badges.py. Rival scores: B30.04.00.00 0.963, B10.04.00.00 0.884. The drawing itself is not in question; only the claim that it was checked against THIS plate rather than a sibling.

Get the dieline

The generator draws this style to whatever dimensions you enter and exports it as a 1:1 PDF, an SVG, or a DXF with the cut, crease and perforation lines on separate layers. Nothing to sign up for.

Open B48.21.00.00 in the generator

Other codes in this group

Browse every code, or read what the groups mean.

Every FEFCO code we build — all 244 of them, grouped.
FEFCO codes explained — what the four digits mean and what each group covers.
How to measure a box — inside, outside and crease-to-crease.
Flutes and calipers — why board thickness changes the blank.