FEFCO 0906 Box Template Generator

Liner sleeve, wrapped about the length. The same closed sleeve turned to run along the length of the case, so it lines the two ends and the top and bottom rather than the sides.

Not yet plate-checked. This template folds, closes and exports cleanly, but its blank has not yet been matched against the standard's own drawing in detail. Treat it as a starting point and check it before you spend anything.

What is FEFCO 0906?

FEFCO 0906 is a part that goes inside another box — a partition, pad, liner or corner piece — rather than a container in its own right. The same closed sleeve turned to run along the length of the case, so it lines the two ends and the top and bottom rather than the sides.

Uses

Transit and e-commerce packing, where the box is handled by a carrier
Protecting or separating goods inside a larger case

Advantages

Cut from a single blank, so there is one tool and one part to stock
Cut from offcuts or lighter board than the outer case, so it adds little cost

Disadvantages

No standard style suits every product; check the fit against a sample before committing to a tool

Typical industries

General distribution and warehousing

Recommended board grades

Single wall B or C flute for partitions and pads. Where the fitment carries the load rather than the outer case, match or exceed the outer box’s board.

At a glance

Code	`0906`
Family	Corrugated (FEFCO)
Blank size at this size	704 × 301 mm
Panels	4
Creases	3

No plate badge, and the reason is measured rather than doubted. This blank shares a fold topology with its siblings in its group, and scored against each of their plates through scripts/settle-shared.py it reaches 1.000 on a rival against 1.000 on its own. A fit that solves for proportions cannot tell two same-topology plates apart, so a match here rules other readings OUT rather than ruling this one in — see the docstring in scripts/grant-badges.py. Rival scores: 0905 1.000, 0904 0.124. The drawing itself is not in question; only the claim that it was checked against THIS plate rather than a sibling.

Get the dieline

The generator draws this style to whatever dimensions you enter and exports it as a 1:1 PDF, an SVG, or a DXF with the cut, crease and perforation lines on separate layers. Nothing to sign up for.

Open 0906 in the generator

Other interior fitments

Partitions, dividers, pads, liners and other components used inside another case.

Browse every code, or read what the groups mean.

Every FEFCO code we build — all 244 of them, grouped.
FEFCO codes explained — what the four digits mean and what each group covers.
How to measure a box — inside, outside and crease-to-crease.
Flutes and calipers — why board thickness changes the blank.