FEFCO 0972 Box Template Generator

Double-ply angle protector, outer plies overhanging. The same two-ply angle board as 0971 folded the other way about: the inner plies take the corner and the outer plies run past the apex instead of tucking inside it, so the overhang shields the corner it wraps.

Not yet plate-checked. This template folds, closes and exports cleanly, but its blank has not yet been matched against the standard's own drawing in detail. Treat it as a starting point and check it before you spend anything.

What is FEFCO 0972?

FEFCO 0972 is a part that goes inside another box — a partition, pad, liner or corner piece — rather than a container in its own right. The same two-ply angle board as 0971 folded the other way about: the inner plies take the corner and the outer plies run past the apex instead of tucking inside it, so the overhang shields the corner it wraps.

Uses

Protecting or separating goods inside a larger case

Advantages

Cut from a single blank, so there is one tool and one part to stock
Locks closed without glue or tape, which saves a consumable and a step
Cut from offcuts or lighter board than the outer case, so it adds little cost

Disadvantages

Hand-locking takes longer per box than a taped or glued closure

Typical industries

General packing and light manufacturing

Recommended board grades

Single wall B or C flute for partitions and pads. Where the fitment carries the load rather than the outer case, match or exceed the outer box’s board.

At a glance

Code	`0972`
Family	Corrugated (FEFCO)
Also known as	reinforced angle board
Blank size at this size	200 × 603 mm
Panels	4
Creases	3

No plate badge, and the reason is measured rather than doubted. This blank shares a fold topology with its siblings in its group, and scored against each of their plates through scripts/settle-shared.py it reaches 1.000 on a rival against 1.000 on its own. A fit that solves for proportions cannot tell two same-topology plates apart, so a match here rules other readings OUT rather than ruling this one in — see the docstring in scripts/grant-badges.py. Rival scores: 0971 1.000, 0973 0.400, 0974 0.400. The drawing itself is not in question; only the claim that it was checked against THIS plate rather than a sibling.

Get the dieline

The generator draws this style to whatever dimensions you enter and exports it as a 1:1 PDF, an SVG, or a DXF with the cut, crease and perforation lines on separate layers. Nothing to sign up for.

Open 0972 in the generator

Other interior fitments

Partitions, dividers, pads, liners and other components used inside another case.

Browse every code, or read what the groups mean.

Every FEFCO code we build — all 244 of them, grouped.
FEFCO codes explained — what the four digits mean and what each group covers.
How to measure a box — inside, outside and crease-to-crease.
Flutes and calipers — why board thickness changes the blank.