FEFCO 0229.1 Box Template Generator

Slotted container with inner lining flaps, across the width. The 0229 construction with the two panel pairs swapped: the rim-and-liner treatment goes on the end (breadth) panels this time, folded almost the full case height, and the plain meeting flap goes on the long (length) panels instead — half the breadth, so it closes across the width rather than the length.

Not yet plate-checked. This template folds, closes and exports cleanly, but its blank has not yet been matched against the standard's own drawing in detail. Treat it as a starting point and check it before you spend anything.

What is FEFCO 0229.1?

FEFCO 0229.1 is cut from one piece, glued or stitched along a single manufacturer’s joint, and shipped flat. Flaps fold in at both ends to close it. The 0229 construction with the two panel pairs swapped: the rim-and-liner treatment goes on the end (breadth) panels this time, folded almost the full case height, and the plain meeting flap goes on the long (length) panels instead — half the breadth, so it closes across the width rather than the length.

Uses

Transit and e-commerce packing, where the box is handled by a carrier
Protecting or separating goods inside a larger case

Advantages

Cut from a single blank, so there is one tool and one part to stock
The most widely made board box there is, so it is quick to source and cheap per unit
Cut from offcuts or lighter board than the outer case, so it adds little cost

Disadvantages

The flaps meet but do not overlap, so the ends are the weakest part of the box

Typical industries

General distribution and warehousing

Recommended board grades

Single wall B or C flute for most shipping. Double wall BC or EB where the load is heavy, the box is large, or it will be stacked several high in a warehouse.

At a glance

Code	`0229.1`
Family	Corrugated (FEFCO)
Blank size at this size	1047 × 529 mm
Panels	17
Creases	16

Get the dieline

The generator draws this style to whatever dimensions you enter and exports it as a 1:1 PDF, an SVG, or a DXF with the cut, crease and perforation lines on separate layers. Nothing to sign up for.

Open 0229.1 in the generator

Other slotted boxes

One piece with a glued, stitched or taped manufacturers joint plus top and bottom flaps. Shipped flat, closed using the flaps.

Browse every code, or read what the groups mean.

Every FEFCO code we build — all 244 of them, grouped.
FEFCO codes explained — what the four digits mean and what each group covers.
How to measure a box — inside, outside and crease-to-crease.
Flutes and calipers — why board thickness changes the blank.