FEFCO 0207 Box Template Generator

Slotted container with an integral egg-crate partition. A plain half-breadth top over a bottom that folds up into its own partition set: the long flaps make a double-thickness divider down the middle, the end flaps two cross partitions a third of the length in from each end, and the slots and wedge notches lock the three together. Four cells from one blank, with nothing to fit.

Checked against the plate. This blank has been compared side by side with the drawing in the FEFCO Code, 12th Edition, and matches. That is a statement about the drawing, not a guarantee — always cut and fold a sample before committing to a die.

What is FEFCO 0207?

FEFCO 0207 is cut from one piece, glued or stitched along a single manufacturer’s joint, and shipped flat. Flaps fold in at both ends to close it. A plain half-breadth top over a bottom that folds up into its own partition set: the long flaps make a double-thickness divider down the middle, the end flaps two cross partitions a third of the length in from each end, and the slots and wedge notches lock the three together. Four cells from one blank, with nothing to fit.

Uses

Protecting or separating goods inside a larger case

Advantages

Cut from a single blank, so there is one tool and one part to stock
Locks closed without glue or tape, which saves a consumable and a step
The most widely made board box there is, so it is quick to source and cheap per unit
Cut from offcuts or lighter board than the outer case, so it adds little cost

Disadvantages

The flaps meet but do not overlap, so the ends are the weakest part of the box
Hand-locking takes longer per box than a taped or glued closure

Typical industries

General packing and light manufacturing

Recommended board grades

Single wall B or C flute for most shipping. Double wall BC or EB where the load is heavy, the box is large, or it will be stacked several high in a warehouse.

At a glance

Code	`0207`
Family	Corrugated (FEFCO)
Blank size at this size	1047 × 457 mm
Panels	19
Creases	22

Get the dieline

The generator draws this style to whatever dimensions you enter and exports it as a 1:1 PDF, an SVG, or a DXF with the cut, crease and perforation lines on separate layers. Nothing to sign up for.

Open 0207 in the generator

Other slotted boxes

One piece with a glued, stitched or taped manufacturers joint plus top and bottom flaps. Shipped flat, closed using the flaps.

Browse every code, or read what the groups mean.

Every FEFCO code we build — all 244 of them, grouped.
FEFCO codes explained — what the four digits mean and what each group covers.
How to measure a box — inside, outside and crease-to-crease.
Flutes and calipers — why board thickness changes the blank.