FEFCO 0233.1 Box Template Generator

Slotted container with locking gabled flaps, tall gusset. The 0233 construction again — the same gabled tab-and-slot lock between the two length-panel flaps — but read independently off its own plate: the gusset crease at each shoulder starts noticeably higher up the side edge (0.144 of the breadth, against 0.088 on 0233), and the bottom and peak depths both run about a percent shallower.

Not yet plate-checked. This template folds, closes and exports cleanly, but its blank has not yet been matched against the standard's own drawing in detail. Treat it as a starting point and check it before you spend anything.

What is FEFCO 0233.1?

FEFCO 0233.1 is cut from one piece, glued or stitched along a single manufacturer’s joint, and shipped flat. Flaps fold in at both ends to close it. The 0233 construction again — the same gabled tab-and-slot lock between the two length-panel flaps — but read independently off its own plate: the gusset crease at each shoulder starts noticeably higher up the side edge (0.144 of the breadth, against 0.088 on 0233), and the bottom and peak depths both run about a percent shallower.

Uses

General packing where a simple, economical board box is wanted

Advantages

Cut from a single blank, so there is one tool and one part to stock
Locks closed without glue or tape, which saves a consumable and a step
The most widely made board box there is, so it is quick to source and cheap per unit

Disadvantages

The flaps meet but do not overlap, so the ends are the weakest part of the box
Hand-locking takes longer per box than a taped or glued closure

Typical industries

General packing and light manufacturing

Recommended board grades

Single wall B or C flute for most shipping. Double wall BC or EB where the load is heavy, the box is large, or it will be stacked several high in a warehouse.

At a glance

Code	`0233.1`
Family	Corrugated (FEFCO)
Blank size at this size	1047 × 368 mm
Panels	13
Creases	12

Get the dieline

The generator draws this style to whatever dimensions you enter and exports it as a 1:1 PDF, an SVG, or a DXF with the cut, crease and perforation lines on separate layers. Nothing to sign up for.

Open 0233.1 in the generator

Other slotted boxes

One piece with a glued, stitched or taped manufacturers joint plus top and bottom flaps. Shipped flat, closed using the flaps.

Browse every code, or read what the groups mean.

Every FEFCO code we build — all 244 of them, grouped.
FEFCO codes explained — what the four digits mean and what each group covers.
How to measure a box — inside, outside and crease-to-crease.
Flutes and calipers — why board thickness changes the blank.